home-For cleanliness and order-Dishwasher-Why does the dishwasher flow from below?

Why does the dishwasher flow from below?

At one point, water may appear under the dishwasher. Immediately you begin to think about leakage. What could be the reasons for the formation of water under the device? This can be found in this article.

Water leak.

If water constantly accumulates on the floor, this can lead to deformation of the floor. He will begin to rot. In the place of moisture accumulation, mold will grow. You will to smell. Water will also spread down the floor, and there is a risk of damage to the ceiling of the neighbors. To avoid this, it is recommended to know the causes of leaks.

In the photo, the water supply valve.

Leakage options.

Small drops of water may appear under the dishwasher. In this case, do not panic. The device gets rid of excess steam inside. Steam turns into small drops of water.

Now, if a puddle formed under the dishwasher, then there is reason for panic. Most likely, one of the parts is damaged.

The most common problems.

What is the leak from? Leakage does not mean a puddle under the machine. Sometimes it can be:

  1. Drops on the floor after the washing process.
  2. Condensation from water vapor. Steam accumulates on the door of the device, and after opening the door it falls onto the floor in the form of water.
  3. Moisture appears under the device.

Any problem can be solved. Drops on the floor may appear due to condensation. Just when you open the door, they hit the floor. This does not mean that the dishwasher is leaking or broken. Another problem is if condensation is constantly accumulating at the bottom of the device. In such cases, you should wait a while after the device is working, and only then open it. Wait until the condensate has completely evaporated. And if drops appeared on the door, they can be wiped with a towel or a dry cloth.

Water flows from the bottom of the device.

With this type of leak, pay attention to the hose. There are several reasons for its leakage:

  1. A crack appeared on it.
  2. The seal was broken.
  3. Slight weakening.

Such cases occur when the dishwasher has been used for several years. Correcting this breakdown is very simple. It is enough to buy a new hose and two clamps needed for a tight connection. All this is inexpensive.

If water flows from the bottom of the device and a large puddle appears, the cause may be a malfunction of the valve through which water enters. He is responsible for the amount of water. If the valve is stuck and it is open, a flood will occur.

Types of malfunctions.

Pictured is a dishwasher tray.

A dishwasher can leak if you use a bad detergent. They can create a lot of foam that penetrates through any seals.

Some dishwashers may function poorly if the jets are not directed correctly. It rocks the following brands:

  1. Simens.
  2. Veko.
  3. Candy
  4. Bosch
  5. Indesit.

In this case, the car begins to leak, because water is sprayed heavily near the door or below. Moisture accumulation starts from the bottom of the device. If your car is leaking heavily, you should check for this problem first. You must also check the door seal of the device and clean it of:

  1. Greasy particles.
  2. Dishwashing residue.
  3. Mud.
  4. Leftover food.

In the worst case, you will have to completely replace the seal.

What other reasons could there be?

Another cause of failure is damage to the seal in the pump. In addition, a problem may occur due to damage to the drain or inlet hose. You can find the cause of the breakdown if you remove the bottom panel of the device. At the same time, it must be turned on. This way you will see where the water flows from. Just watch the accumulation of moisture carefully. But be careful with the wires. They are energized, and water passes electricity well and therefore dishwasher may cause electric shock.

Another known problem is the formation of holes through which species can flow. Sometimes the reason is a poorly closed latch on the door. It may be damaged or bent, causing water to flow under the machine. It is also one of the reasons - a seal on the door. Cracks may also form on it. Especially if the machine has been running for several years.

Other reasons.

Pictured is a Bosch dishwasher inside.

There are several more reasons for leaks:

  1. If water flows from the bottom of the door, the dishwasher may be skewed and not standing properly. In addition, contamination of the nozzle may be the cause. It could also break water level sensor in the device. The door seal may have been smeared, or grease has accumulated on it. You can clean it with a rag. If it is damaged, you will have to replace it.
  2. The machine may leak from below if the rubber tube has been torn or poorly connected. This is a fairly common problem in cheap dishwashers (sellers saved on quality). Another reason may be old equipment.
  3. The cause may be in the air gap of the drain valve. A part is installed in the drain hose so that water cannot flow into the sewer. Water may leak out of the ventilation if the hose has a small hole or is clogged with grease and dirt. But then the leak will occur during the discharge of water.
  4. Damaged water storage tank. Perhaps the tank burst. In this case, a puddle appears under the machine. This problem is quite rare.
  5. Defective sprinkler. It is also quite rare. If it is damaged, water will begin to flow into all parts of the machine and accumulate below.

Can I fix the malfunction with my own hands?

If you are familiar with the instructions, and know where the details of the device are, you can try to fix the problem with your own hands.

If water flows from the bottom of the door

This is the most easily fixed damage. Gum can be bought at any hardware store. Please note that for each brand of dishwasher you need a different elastic band.

To replace the gum on the door you need:

  1. Open the doors, and remove the bolts around the perimeter.
  2. Close the door and remove the front panel.
  3. Now open the door and remove the basket for dishes.
  4. Using tweezers, remove the sealant layer.
  5. Install a new one. Its end should coincide with the edge of the container with water.
  6. We put the panel back.

If the problem is in the hose and pipe.

You need clean the filters and hoses in the dishwasher from food debris and fat. The filter is located at the bottom of the water tank. You need to remove the mesh, and unscrew the cup. Wash everything under water and reinstall.

If there is a problem with the hose or pipe, they just need to be washed with water.

And if one of the listed parts is damaged, you will have to replace it.

Cleaning the machine with napkins.

Replacing a valve, sprinkler or water sensor.

If there is rust on the filler valve, it must be replaced. Just disconnect the pipes and sensors from it, and install a new one.

Very rarely, but it happens that due to water pressure, the sprinkler begins to delaminate. Water begins to flow into the pan. You can buy a new sprayer, and replace it with your own hands. It can be in different places depending on the brand of the dishwasher. Most often, it is installed under the basket for dishes. The sprinkler is held by means of latches. Just pull it out with a screwdriver and install a new one.

Burst tank.

Sometimes it happens that a container of water bursts. Most often this happens if the device is already old. Here you have to contact the master. Most often, damage to the tank leads to the purchase of a new dishwasher, since repairs are expensive.

In almost all cases, except the last, replacement of parts can be done with your own hands.

Advice.

If you decide to buy a dishwasher, choose the device in proven places. Do not try to save on price and quality, so as not to run into a bad product.

Pay particular attention to the choice of detergent. The life of the dishwasher also depends on this.

The device must be constantly looked after. Wash the dishwasher on time, remove all food residue and dishwashing detergent. Also inspect parts for corrosion or cracking.

As you can see, there are many reasons why a dishwasher is leaking. You can determine the damage yourself by removing the bottom panel of the device. If you didn’t succeed, you can always turn to an expert for help.

Also, by clicking on the link, you can find out about another breakdown: For what reasons water does not leave the dishwasher?

Comments (1)
  1. Grisha Molokov:

    Azm!